![]() ![]() ![]() Performance during simultaneous use of IEEEĨ02.11 and Bluetooth with a single antenna. Offers the benefits of a module – small formįactor, easy integration and certifications.īluegiga also provides WF111 drivers for theĮncryption protocols and for various coexistence schemes which enables exceptional System and a TCP/IP stack on-board, but still Solution for devices that run an operating WF111 provides a low cost and simple Wi-Fi WF111 is a fully integrated single 2.4GHz bandĨ02.11 b/g/n module, intended for portable andīattery powered applications, where Wi-FiĬonnectivity is needed. 28Īntenna switch for Bluetooth coexistence. 12ĬSR Serial Peripheral Interface (CSPI). The Bluetooth trademark is owned by the Bluetooth SIG Inc., USA and is licensed to Bluegiga Technologies.Īll other trademarks listed herein are owned by their respective owners. The WRAP, Bluegiga Access Server, Access Point and iWRAP are registered trademarks of Bluegiga Bluegiga’s products are not authorized for use as critical components in life support devices I'll be very pleased if you can help me.Copyright © 2000-2012 Bluegiga Technologiesīluegiga Technologies assumes no responsibility for any errors which may appear in this manual.įurthermore, Bluegiga Technologies reserves the right to alter the hardware, software, and/or specificationsĭetailed here at any time without notice and does not make any commitment to update the informationĬontained here. The control signal is output through the blue/white lead, even. Connect to an external power amp’s system remote control terminal, the auto-antenna relay control terminal, or the antenna booster power control terminal (max. To open the charger is very easy you just need get of the screws beside and of the fan and a trick is get of also those blue pins wich we choose the function, get of then with the pliers. When the ignition switch is turned on (ACC ON), a control signal is output through the blue/white lead. So, the picture is there and those IC's marked with red square are burned, I can change those if I have their reference but after burned I can't see. So strange, here is good because we can exchange experiences like that. Those charger are very strange, have you tried to see the current potency on each cell if is really ballancing, I've tried many times when the balance function was working well but It was always unbalanced. But it's faster than when it's charging and balancing. In todays racing, traction dictates your setup - period With both B6 and B6D configurations available, getting to the top of the podium has never been easier. It's not funny, I read about your problem and I have some problem with my charger, when I'm charging in normal mode, without balance the Discharge goes down, until it charge everything. Thanx GOD, you sent someone to help me! KKkK.įriend, I haven't used my charger since I burned those IC, It's working like I said but without balance function. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
December 2022
Categories |